12V 0.8MPA Oil Extractor Pump Kit, Keenso Auto Car Oil Fluid Liquid Extractor Scavenge Exchange Transfer Pump

Keenso — Oil Extractor Transfer Pump uses 12v mini self-priming pump to exchange car engine oil. It works by connecting the clamps to the 12V car-battery,and widely used in general industrial equipment, cause this pump can pump oil not only, also can pump hydraulic oil and other liquid. How to use: 1. Start to run

Keenso — Oil Extractor Transfer Pump uses 12v mini self-priming pump to exchange car engine oil. It works by connecting the clamps to the 12V car-battery,and widely used in general industrial equipment, cause this pump can pump oil not only, also can pump hydraulic oil and other liquid.

How to use:
1. Start to run the car engine for a while, when oil temperature turns to be about 50 degrees, start pumping oil.
2. Connect the pump to the power, run it for a while, and observe whether the inlet and outlet is normal.
3. Open the filler cap,get dipstick out, force the tube into the bottom of the joint, until the tube does not move; then put the inlet pipe from the oil dipstick into in end (the tube into the bottom of the tank, the bottom concave place, in order to pump the oil completely); as no oil or pumping up very slowly or intermittently, it is generally caused by loose pipes and fittings. 
4. After oil pumping, remove the tube, and then run the pump for a while, pump the remaining oil inside the pumping clean
5. If you have not used it for a long time, it may have no suction, then just pour the water in the pump, and run the pump for a few minutes until the air is all out.

Specifications:
Rated Voltage: DC 12V
Rated Power: 60W
Maximum Pressure: Max. 0.8MPA
Maximum Flow: 5L/min
Pump Diameter: Approx. 4.8cm / 1.89″
Length: Approx. 14.5cm / 5.7″
Outlet Pipe Size(Dia.*L): Approx. 11mm*140cm / 0.43″ * 55″
Inlet Pipe Diameter: Approx. 8mm & 6 mm / 0.31″ & 0.24″
Inlet Pipe Length: Approx. 100cm / 39.37″
Cable Length: Approx. 30cm / 11.8″
Clips Length: Approx. 8cm / 3.15″

Package Inculded:
1 x oil pump
1 x 11mm outlet pipe
1 x 8mm inlet pipe
1 x 6mm inlet pipe
2 x clips 

Product Features

  • △【Premium Quality】– 12V Transfer pump ideal for filling diesel powered vehicles or engines at your garage or repair shop, Maximum Pressure: Max. 0.8MPA
  • △【High Performance】– Battery powered 12 volt allows this pump to be used in deferent environments, an ideal equipment for quick and clean oil-changes, comes with 11mm/8mm/6mm pipe
  • △【Simple on/off Switch】– Oil & Fuel Transfer Extractor Pump with self-priming, rotating vane pump with an on/off switch and an inner bypass valve ensures reliable operation every time, very easy to use
  • △【Widely Applications】 — Widely used in general industrial equipment, medical equipment, chemical equipment, shipbuilding, drinks, carpet and floor cleaning, water purification and water treatment equipment, vehicle cleaning, agricultural spraying, zo pipeline pressure, air cleaning cooling, coal and metallurgical industries
  • △【Warm Prompt】– 1.If you want to connect this pump to AC power, you will need a power converter; 2.Please use when the engine is warm, the engine oil is warm and viscosity is lower, this will be easier and faster to pump; 3.This product is not allowed to pump corrosive liquids, strong acids and strong alkaline liquids